2 ATA Hyperbaric Chamber

Quest30, Quest36 and Space60 come in two steel builds. The 2.0 ATA build adjusts from 1.4 to 2.0, and the 1.5 ATA build from 1.2 to 1.5. A 1.5 build cannot be turned up later. For a 1.5 ceiling, compare our 1.5 ATA hyperbaric chambers.

The 2.0 build has a pressure range of 1.4 to 2.0 ATA, so it does not go lower. If you also want lighter sessions, the OxyRevo Space60 Pro runs 1.1 to 2.0 ATA in one build. Lighter protocols can also look at 1.3 ATA hyperbaric chambers and 1.4 ATA hyperbaric chambers.

Only a hard shell chamber holds 2.0 ATA. Every OxyRevo model in our hard shell hyperbaric chambers range offers a 2.0 build. Our soft shell models top out at 1.5. If 1.5 is enough, portable hyperbaric chambers cost less and pack away. Newtowne Hyperbarics offers soft chambers too. Hospitals run clinical protocols in chambers rated up to 3 ATA. We do not sell 2.5 or 3 ATA models.

In hyperbaric oxygen therapy (HBOT), you breathe concentrated oxygen through an oxygen mask. Higher pressure lets more oxygen dissolve into blood plasma. Each 2.0 ATA hyperbaric oxygen chamber here is equipped with a 10 L oxygen concentrator. Oxygen delivery runs at 90 to 97% purity, per OxyRevo.

OxyRevo chambers are CE certified to European safety standards, not FDA approved or cleared. Their intended use is general wellness and recovery, not medical treatment. Clinics should confirm FDA clearance status and NFPA 99 facility rules.

Looking for an exercise-ready hard shell hyperbaric chamber at 2.0 ATA? None of the four here is built for exercise inside. Each is a lying cabin or a recliner.

The OxyRevo Quest30 has the lowest 2.0 build price. It is also the lightest of the four.

The OxyRevo Quest36 adds 6 in of width over the Quest30. Every flat format we sell sits in lying hyperbaric chambers. Bigger users can also browse large hyperbaric chambers and x-large hyperbaric chambers.

The OxyRevo Space60 gives 60 in of height and a folding recliner. See every upright soft and hard model in sitting hyperbaric chambers.

The Space60 Pro sets pressure in 0.1 steps from touch screens inside and out. Clinics and studios buying more than one unit should see our commercial hyperbaric chambers.

OxyRevo builds the Quest36 for personal use at home or daily use in a clinic. Our home hyperbaric chambers cover every setup for a house. Athletes on a training schedule can compare hyperbaric chambers for athletes.

No 2.0 ATA chamber here takes a wheelchair. The soft OxyRevo Heal40 does at 1.4 ATA, as does our wheelchair accessible hyperbaric chambers range.

Measure the narrowest point, turns included. The Quest30 crate is 37 in wide and the Quest36 crate 43 in. The Space60 Pro side windows do not come off. We confirm the right hyperbaric chamber for your route.

Weights are in the table above. The sitting models are heaviest, so plan a ground floor or slab.

The Space60 operating unit draws 1,700 W on 110V or 220V. The Space60 Pro draws 1,700 W, or 2,500 W with the 20 L oxygen upgrade. Plan the circuit and room ventilation before delivery. Change the compressor filters every 6 to 12 months to maintain the system.

On the Quest models you control pressure, oxygen and cooling from a panel inside. It reaches pressure in about 12 minutes. A full session of hyperbaric therapy runs 60 to 120 minutes, per OxyRevo. The Quest30 spec calls for room air conditioning above 68°F room temperature.

A pressurized environment with concentrated oxygen raises fire risk. For user safety, each manual lists its safety systems and what you can take in. It normally restricts ignition sources, battery devices and oil-based products.

We do not sell used 2.0 ATA chambers. Every chamber is new and built to order.

Find the same configuration for less and we match it plus 20% of the difference. See our 120% price match terms.

As an authorized dealer, your chamber carries the full OxyRevo factory warranty with direct manufacturer support.

Personal and business lenders in the USA and Canada. Insurance rarely covers a home chamber. See hyperbaric chamber financing for terms.

A guided video installation walkthrough, plus three more sessions if needed. White glove delivery is a paid add-on. Call 866-861-6317, 9am to 6pm EST, Monday to Friday.